How to install driver on mini fiber laser marker

  1. Motion board signal cable connect with driver

In the motion board it has leave six signal,two green signals,one red signal,one black signal,one white signal,one blue signal,one yellow signal

We let yellow signal,blue signal,white signal connect with driver

Your motion board six signal picture

Yellow signal,white signal,blue signal connect with driver step:

Yellow signal cable connect +5V

White signal cable connect PUL-

Blue signal cable connect DIR-

Pls kindly note,the signal cable is already have,just connect with driver,it is okay.

2.Laser power supply signal cable connect with driver:

Make two new signal cable,one connect laser power supply V-,the other connect with V+

Let the signal cable which connect laser power V- connect Driver GND port

Signal cable which connect Laser power V+ connect driver +V

See following pictures

3.Rotary device motor wire connect with Driver step

Four signal cable of rotary device motor connect diver

Any questions or inquiry ,please don’t hesitate to tell us,thanks for your kind attention on XT LASER
Please contact Mr.Kevin
Jinan Xintian Technology Co.,Ltd  (XT LASER) 
| Add:No.316 Xinggang Road,Jinan city,Shandong province,China.
|Cellphone:008615053145819                         |
|Tel:+86 531 88558038                                       |Fax:+86 531 81180745
|Whatsapp:008615053145819                         | Skype: lasermachine01